BAUR frida VLF testing and diagnostics unit

• High performance and compact
• Precise and non-destructive determination of the cable condition
• Easy and quick test setup
• Automatic testing and diagnostic sequences

 

• Continuous adjustable output voltage
• The voltage measurement is done directly at the high voltage output
• Timer of 1-30 min
• Sensitive current measurement for recording the smallest of insulation currents with 6-time range switch, decadal

 

• Precise and non-destructive determination of the cable condition
• Easy and quick test setup
• Automatic testing and diagnostic sequences
• Compact dimensions and lightweight

 

• Output energy up to 50 VA
• Automatic or manual impedance adjustment
• Charging unit and rechargeable battery integrated; battery or mains operation
• Continuous or cyclical output

 

• Fully automatic dissipation factor measurement
• Pre-programmed standards
• Maximum accuracy

 

• Automatic PD detection during normal mains operation (without switching off the cable route)
• With DeCIFer® technology: PD identification based on 500 million measurement results
• Precise online PD mapping with PD transponder

 

• Cable identification on all types of de-energised cables
• Reliable verification of the cable identification by means
• of the highly precise three-factor-analysis ATP
• Safe cable identification on live low-voltage cables
• Connection technology according to CAT IV/600 V

 

• Compact and robust device for portable use onsite
• Test voltages from 0 to 75 kVrms
• Repeatable breakdown measurements in mineral, silicone and plant oils
• Reliable measurement results due to its short switch-off time (< 10 ½s)

 

• Testing of medium- and high-voltage cables
• DC voltage testing of up to 110 kV output voltage with positive or negative polarity
• AC voltage testing - up to 80 kV for switchgear, busbars and insulating elements
• Easy-to-maintain 2-piece design

 

• Battery mode
• Zero point compensation
• Accurate location of cable sheath faults
• Battery test