Locatoare defecte cabluri | MEGGER

• 0-25,000 ft continuous
• Automatic or manual range selection
• Optional sectionalizing

 

• minimum resolution of 0.1 m and a 5 km maximum range
• Simple operation.
• AUTO selection of gain and pulse width.
• Ultra fast pulse for near end fault identification.
• Trace HOLD feature.
• IP54 rating offers real life working.
• Designed for use on all metallic cable pairs.

 

• minimum resolution of 0.1 m and a 5 km maximum range
• Simple operation.
• AUTO set up for instant use.
• Ultra fast pulse for near end fault identification.
• Trace HOLD feature to allow comparison between cables.
• IP54 rating offers real life working.
• Designed for use on all metallic cable pairs.

 

• TDR1000/3P is suitable for use on both dead or live cables
• Simple operation
• AUTO set up for instant use
• Ultra fast pulse for near end fault identification
• Trace HOLD feature to allow comparison between cables
• IP54 rating offers real life working
• No blocking filters require
• Supplied with fused test leads

 

• 20 km range at VF = 0.90
• Monochrome or colour options
• Primary cell or rechargeable options
• Large back lit LCD Display
• Dual cursor measurement
• Intermittent fault location
• Output pulse amplitude and width control
• Trace Master PC software included
• IP54 Rating
• 2 year Warranty

 

• TDR20000/2P can perform single or dual channel measurements on a wide range of metallic cables
• dead or Live cables to CATIII 300V Phase to earth or 415V phase to phase can be tested.

 

• best resolution of 0.1m the TDR2000/2 has a 20km maximum range
• Comprehensive Dual Channel capability with dual aspect display.
• AUTO set up mode for instant use.
• Ultra fast pulse for near end fault identification.
• Xpert guidance to potential fault.
• IP54 rating offers real life working.
• Designed for use on all metallic paired cables.

 

• Full autoranging for measuring the length of power, telephony, CATV and LAN cables, provides distance to an open or short.
• Extra large, high resolution backlit LCD.
• Automatic output impedance control of 25, 50, 75, 100, 125 or 150 ohms.
• User-friendly menu on screen operation.
• Cable length calibration function.
• Internal library of 39 standard cable types.

 

• Evaluate capability of link connections and locate faults up to 500 meters
• 1000BASE-T, auto measurement of signal performance, wiremap and length
• Large high resolution backlit display
• 1 kHz analogue tone signal output
• Built in TDR and TDX
• Evaluate the capability of link connections and locate faults up to 500 meters
• Detect Wiremap failure (Pass, Fail, full Wiremap details (extended test))
• RJ45 and BNC connectors
• 10 BASE-T and 100 BASE-TX Ethernet, half- or full- duplex support