With the PHG TD/PD, you get a multifunctional cable testing and diagnostics system that was specially designed and developed for medium-voltage networks. The PHG TD/PD system is also the only cable testing and diagnostics system that gives a comprehensive overview of the quality and ageing condition of the test sample. The diagnostic methods TD and PD are mutually complementary, because on one hand you can detect the complete condition and on the other hand locate individual faults in the operating resources.

Features:

Biggest dynamic range of tan delta measured values from 1 to 10-4 with a cable capacitance >10 nF to 20 uF
High resolution +/- 1x10-5 applicable even in new PE/XLPE cables
Insensitive against interferences due to complete mains separation
Lowest time required for assessing a medium-voltage cable (3-phase approx. 1 hour)
Compact, enclosed design in 19½ format
Variable installation option with separate control and voltage unit
Variable connection options to cable stations of different models

Alte produse BAUR

BAUR TG 600 AUDIO FREQUENCY TRANSMITTER

• High-performance audio frequency transmitter up to 600 VA
• Frequency of 2 or 10 kHz, quartz-stabilised (other frequencies on request)
• Potential-free output
• Impedance adjustment in 8 steps from 0.3 to 300 O

BAUR DTL C OIL BREAKDOWN VOLTAGE TESTER

• Fully automatic dissipation factor measurement
• Pre-programmed standards
• Maximum accuracy

BAUR FRIDA TD VLF TESTING AND DIAGNOSTICS UNIT

• Cable testing and dissipation factor diagnostics in one device
• Easy and quick test setup
• Automatic testing and diagnostic sequences
• Compact dimensions and lightweight

BAUR TG 20/50 AUDIO FREQUENCY TRANSMITTER

• Automatic or manual impedance adjustment
• Charging unit and rechargeable battery integrated; battery or mains operation
• Continuous or cyclical output
• Two output frequencies selectable

BAUR PAULA PHASE DETECTOR

• Clear phase determination possible in cable lengths up to 40 km
• Highest level of safety when used on earthed and shorted cables in compliance with EN 50110-1 (DIN VDE 0105-100)
• Suitable for all switchgear constructions due to compact design of the signal injectors
• Ready for operation for up to 2 weeks (standby mode)

BAUR PGK 25 DC HIGH-VOLTAGE TEST DEVICE

• Compact device for DC voltage testing with negative polarity
• Continuously adjustable output voltage
• Perfect for mobile use

BAUR LIONA ONLINE PD SPOT TESTER

• Automatic PD detection during normal mains operation (without switching off the cable route)
• With DeCIFer® technology: PD identification based on 500 million measurement results
• Precise online PD mapping with PD transponder

BAUR PGK 150 / 5 HB HIGH-VOLTAGE TEST DEVICE

• Testing of medium- and high-voltage cables
• DC voltage testing of up to 150 kV output voltage with positive or negative polarity
• AC voltage testing - up to 110 kV for switchgear, busbars and insulating elements
• Easy-to-maintain 2-piece design

BAUR PHG 70 / PHG 80 PORTABLE VLF TEST SYSTEM

• 3 voltage shapes in one device: VLF truesinus®, VLF square wave and DC voltage
• For medium-voltage cables of up to 50 kV operating voltage
• Cable testing, fault conditioning, cable sheath testing

BAUR PD-SGS HANDHELD ONLINE PD DETECTOR

• Initial rapid condition evaluation of switchgear and cable accessories during mains operation
• Ideal for quick checks of MV and HV switchgear