Extech MN10 Multimetru de buzunar

• 250V, 500V and 1000V Test Voltages
• Measure Insulation Resistance to 10GOhm
• Large LCD display with analog bargraph
• Lo Ohm function for testing connections

 

• Measure White, Red, Yellow, Green, and Blue LED and Standard Lighting in Lux or Foot-Candle (Fc) units
• Manually store/recall up to 99 readings
• 4000 count LCD display
• Cosine and color corrected measurements
• Min/Max Average and Auto Power Off
• Complete with light sensor with protective cover and coiled cable expandable to 59" (1.5m), 9V battery, and hard carrying case

 

• Four terminal Kelvin measurements
• Over-temperature and over-voltage protection
• 5 ranges with 100µOhm max resolution
• Invalid test indicators prevent inaccurate measurements
• Built-in water resistant case with shoulder strap

 

• 3-phase Voltage or Current Unbalanced Ratio (VUR, AUR) and unbalanced factor
• Capture Transient events (including dip, swell, and outage) with programmable threshold (%)
• Log up to 30,000 reading on a removable SD memory card in Microsoft Excel® format
• Wide sampling rate range (2 seconds to 2 hours)
• Built-in Clock and Calendar

 

• Source 0 to 24mA with 0.01mA resolution
• Measure 0 to 50mA (0.1mA resolution)
• Select Type K, J, or T thermocouple for precision calibrations in °F/°C or mV
• Output 0 to 1999mV or 0 to 10.00V
• Measure 0 to 19.99V

 

• Alternately displays Carbon Monoxide (CO) concentration, Air Temperature, and Relative Humidity readings (cycles approximately every 6 seconds)
• Visible bright tri-colored (green, yellow, red) LED alarm indicator
• Adjustable audible alarm for readings exceeding one of the selected ranges: 25ppm, 30ppm, 35ppm, 50ppm, 100ppm or 200ppm
• ZERO Re-Calibration function
• Manual Temperature and Relative Humidity Compensation (adjustable)
• CO Calibration function in fresh air

 

• Large easy to read digital display
• AC/DC Voltage, DC Current, Resistance, Type K Temperature, Continuity/Diode
• 1.5V and 9V Battery test function
• Convenient mini size with protective rubber holster and tilt stand
• Data Hold locks reading in the display
• Includes protective rubber holster, 9V battery, bead wire Type K temp. probe and test leads

 

• Built-in Datalogger stores up to 1,012 readings (single record/continuous datalogging)
• Four simultaneous displays of Watts, Power Factor or VA, Voltage or Hz, Amps
• True RMS Voltage & Current measurements of sine, square, triangular and distorted wave forms with a crest factor < 5
• Plug device to be tested directly into the Power Analyzer

 

• True RMS for better accuracy when measuring distorted waveforms
• 2000 count large backlit dual LCD with easy-to read digits
• Low current capability with resolution to 0.1µA
• Input fuse protection
• Max Hold, Data Hold and Auto power off
• Complete with test leads and 9V battery

 

• Constantly calculates and adjusts the Voltage and Current limit points according to available maximum power (160W)
• At maximum current (10A), voltage is limited to 16V
• At maximum voltage (42V), current is limited to 3.8A
• Dual action rotary encoder control with push knob for fine and coarse tuning