ELQ 35 is a hand held battery operated, multifunction measuring instrument, intended for pre-qualification, installation, fault location and maintenance of balanced copper pairs

Features:

Pre-qualification in Master Slave mode
Pre-programmed Tolerance Masks
Automatic Data Rate Calculation
Immediate PASS/FAIL indication
Single Sided Measurements
Service Telephone Function
PC Supported Spectrogram
Long Time Micro Interruption Measurement
Long Time Impulse Noise Measurement
High Impedance Active Test Probe
PC Control Program

Alte produse ELEKTRONIKA

TESTER NIVEL LINIE 2,4 MHZ LEVEL TEST SET ELEKTRONIKA ET91

• Psophometer
• Autmatic End to End Measurements
• High Resolution Spectrum Analyzer
• Measuring Bridge
• Memory Locations for Test Setups

PUNTE MASURA DETECTIE DEFECTE CABLU ELEKTRONIKA ECFL30

• Capacitance Measurements
• DC Fault Location Methods
• AC Fault Location Methods
• Graaf Fault Location Method
• TDR Measurements

LOCATOR DEFECTE CABLURI TELECOM TELEFONIE ELEKTRONIKA EFL 10

• Loop resistance measurement
• Resistance difference measurement
• Mutual capacitance measurement
• Conductor-shield capacitance measurement
• Break and split measurement
• DMM functions

CALIFICATOR LINII XDSL XDSL ELEKTRONIKA ELQ2+

• TDR for fault location
• Load coil detection facility
• DC-AC bridge option
• 2.2 MHz frequency range for fix-frequency and spectrum measurements
• Longitudinal voltage protection

TESTER TELEFONIE COMUNICATII & DSLAM ELEKTRONIKA ETET30

• SIX INSTRUMENTS IN ONE
• DMM LINE TESTER
• EXCHANGE SIMULATOR
• TELEPHONE SIMULATOR
• GOLDEN MODEM
• SPECTRUM ANALYZER
• TDR

ANALIZOR SEMNALE TELECOMUNICATII ELEKTRONIKA ESA10

• External clock input
• 320 x 240 dot LCD display
• LED indicators showing settings and status of line signal
• Selectable English or Russian languages
• Internal rechargeable battery-pack
• USB interface to connect to PC

ANALIZOR ISDN ELEKTRONIKA EIT10

• BRI TE and NT simulation, monitoring
• PRI TE and NT simulation, monitoring
• Dual U interface for troubleshooting between the NT and the Exchange
• B-channel voice and D-channel signaling monitor
• EDSS1, V5.1/V5.2, QSIG, SS7 protocols
• Analysis of CAS (R1,5; R2

TESTER SERVICII XDSL & TROUBLESHOOTER ELEKTRONIKA EX30M

• Transmitted power
• Line attenuation
• Line alarms (LOS, LOF, LOP, LOM)
• Line errors (FEC, CRC, HEC)
• Ping test / trace route

TESTER LINII DE DATE DIGITALE ELEKTRONIKA EDCT2A

• CAS status analysis
• Auto-configuration function
• Storage of set-ups and results
• Voice channels monitoring through built in speaker
• External clock input

CALIFICATOR RETELE CUPRU CABLU ELEKTRONIKA ELQ30A+

• Analogue measurements on leased or switched circuits 20 Hz to 20 kHz
• Analogue-to-analogue measurements on PCM systems
• Loop holding and dialling (pulse or DTMF) for dial-up circuit testing
• Built-in loudspeaker and microphone, service telephone
• In-service talk/listen and voice monitoring facility