Analizor spectral RF 9 kHz..6.2GHz ED PSA-6000

• Belt-type conveyor simulator
• Control Modes : manual or automatic by programmable Logic Controller
• Three photo sensors and two motion solenoids

 

• DC motor’s load characteristics
• DC motor’s loss and efficiency
• Alteration of the motor’s rotative directions
• Motor’s speed and torque

 

• Hexadecimal number indicators
• Selectable pulse outputs
• Built-in DC power supp

 

• The optional Embedded System(ED-255EK) can be linked as a gateway
• ZigBee network can be built using TinyOS, F8WOS
• Capable of control and monitor through Ethernet
• The RFID Card Reader is supplied as a standard shipped component for applied experiments on security, home automation and robot

 

• Experiments on various types of special control unit
• Characteristics of Servo Motor and setup of Servo Driver
• Essential components in automation using a PLC position module
• 4mm banana jack to increase wiring capability

 

• Maximum Operating Pressure : 3Mpa(30kgf/cm2)
• Hose’s Diameter : Outside ø6/Inside ø4
• Hose’s Length : 1500mm
• Rectangular Block Type

 

• One-stop training kit for embedded system, DSP and FPGA
• 7" Wide TFT LCD, 10/100 Ethernet 1Port, Serial 1Port, SD/MMC, ATA and other interfaces

 

• Designed to help develop network devices on the basis of Lon Protocol
• Control of each device installed in the field through power line communication
• Related experiments through Neuron C and MICOM programming
• Home network control in utilization of LabVIEW

 

• Inverse current protection
• Built-in charge controller and bulit-in battery
• Overcurrent/electric discharge protection
• 360° rotation by the direction of wind
• Configurable composite structure by adding optional

 

• Conversion experiments on the produced energy(power production/processing)
• Characteristics of Solar Cell module’s voltage and current
• Alarm beep for wrong wire placement
• Voltmeter and ammeter as included for measuring AC and DC
• Control by PC and waveform and graph output