Camera video inspectie tevi, conducte, canale Extech BR150

• Combines non-contact voltage and light detection with RF (Radio Frequency) transmission technology
• Remotely identifies mid-run AC wiring, circuit breakers, switched lines, AC outlets, and light fixtures
• Non-contact mid-run AC wiring identification without cutting into wires
• Lighting circuit identification using built-in light sensor

 

• Alternately displays Carbon Monoxide (CO) concentration, Air Temperature, and Relative Humidity readings (cycles approximately every 6 seconds)
• Visible bright tri-colored (green, yellow, red) LED alarm indicator
• Adjustable audible alarm for readings exceeding one of the selected ranges: 25ppm, 30ppm, 35ppm, 50ppm, 100ppm or 200ppm
• ZERO Re-Calibration function
• Manual Temperature and Relative Humidity Compensation (adjustable)
• CO Calibration function in fresh air

 

• 7 ranges for wide low resistance measurements
• High resolution to 0.01mOhm
• 1999 count display with 0.8" digits
• 4-wire test cable with Kelvin clip connectors
• Automatic zero
• Built-in comparator for Hi/Lo/Go resistance testing or selection

 

• Accurately displays light level in terms of Fc or Lux over three ranges
• Select fast (1 second) or slow (2 seconds) response time
• Analog output of 1mV per count for capturing readings to a recorder

 

• Large easy to read digital display
• AC/DC Voltage, DC Current, Resistance, Type K Temperature, Continuity/Diode
• 1.5V and 9V Battery test function
• Convenient mini size with protective rubber holster and tilt stand
• Data Hold locks reading in the display
• Includes protective rubber holster, 9V battery, bead wire Type K temp. probe and test leads

 

• Built-in sensors measure Air Velocity, Air Flow, Temperature, Humidity, Wet Bulb, Dew Point, Heat Index, Wind Chill, Barometric Pressure, Altitude, and Light
• Field replaceable low friction vane wheel improves air velocity accuracy
• Backlit LCD display (auto off after 5 seconds)
• Data Hold, Auto Power Off, Auto-rotating display depending on function
• Complete with built-in multiparameter sensors, wrist strap, and CR2032 battery

 

• Simultaneous display of Pressure, Air Velocity or Air Flow plus Temperature
• ±0.7252psi range
• 5 selectable units of pressure measurement
• Max/Min/Avg recording and Relative time stamp
• Data Hold and Auto power off functions

 

• Designed for professionals who routinely audit existing and replacement lighting systems for energy efficiency and lighting performance
• Kit includes:
• LT300 - Light meter with digital and analog display of light in Foot-candles or Lux
• DT200 - Compact laser distance meter with area/volume calculation functions
• Supplied in a soft carrying case that provides protection and organization for the meters whenever they are needed

 

• Transmitter with output cables terminated in modular RJ11 phone connector
• Transmitter injects traceable signal into cables, checks telephone lines, and performs continuity checks
• Non-Contact probe audibly identifies selected wire or cable
• Easily trace wires from source to termination
• Test for properly operating phone lines

 

• Sursa de semnal: iesire in curent 0-24mA (max 1000ohm)
• Masurare semnal: 0 -50mA
• Sursa de alimentare: 24Vcc pentru alimentare in bucla de curent
• Precizie: 0.01% ±1 digit
• Temperatura operare: 5ºC...40ºC