Politici de confidentialitate

Date GDPR Termeni utilizare Politica cookies Confidentialitate Livrare si plata Cum comanzi?
Accept conditiile de utilizare Continua
 
office@distek.ro  +40 760952425   Cere ofertă (0) 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 


Omicron MONGEMO Permanent on-line partial discharge monitoring system for power generators and electrical motors

Cod: Omicron MONGEMO


 
Brosura produs PDF, 1.61 Mb
     

Descriere

MONGEMO is a customizable, permanently installed system for the continuous on-line monitoring of partial discharges (PD) in the stator windings of rotating machines. 

 

Using the system½s convenient Web interface, you can remotely configure the monitoring system, view real-time data and trends, and analyse the collected raw data.

 

MONGEMO provides you with warnings and alarms when PD activity reaches or exceeds pre-set threshold values. Using this actionable data, you can assess the risk of dielectric failure in your machines and optimize your maintenance strategy.

 

PD monitoring data from MONGEMO can be easily exported to SCADA systems.

 

Features:

  • Customized system approach to match specific monitoring requirements
  • Synchronous, four-channel PD data acquisition for complete PD assessment
  • Advanced noise suppression and fully automated PD cluster separation for convenient evaluation
  • Recording of raw PD data at selected intervals for in-depth post analysis
  • Seamless integration with third-party monitoring devices and SCADA systems
 

Alte produse OMICRON

OMICRON CPC 80/CP TD1 CAPACITANCE/DISSIPATION FACTOR TEST SYSTEM

• Reliable and exceptionally precise results even under extreme conditions due to excellent noise suppression
• Automated storage of test results and report generation
• Built-in safety features provide highest operator safety during testing

 
OMICRON CMS 356 VOLTAGE AND CURRENT AMPLIFIER

• Calculation and output of residual voltage and current
• Parallel connection of several CMS 356 units for even higher current amplitudes
• All current and voltage outputs are fully overload and short circuit proof

 
OMICRON FRANEO 800 SWEEP FREQUENCY RESPONSE ANALYZER

• Reproducible results thanks to an innovative connection technique
• Guided workflow for test setup, execution and assessment for easy analysis without expert knowledge
• Fast measurement times due to the intelligent sweep algorithm
• Extremely small and compact device guarantees optimum usability

 
OMICRON CMC 310 TEST SET FOR BASIC THREE-PHASE TESTING

• Easy manual testing with the CMControl P unit and the CMControl P App running on a Windows PC or an Android Tablet
• Portable and lightweight testing solution
• Reduced testing efforts, increased productivity

 
OMICRON VOTANO 100 ACCURATE AND MOBILE VOLTAGE TRANSFORMER TESTING AND CALIBRATION SYSTEM

• Determination of VT ratio and phase angle accuracy for different voltage levels
• VT winding resistance measurement of secondary windings
• Determination of magnetization characteristics
• Leakage reactance measurement

 
OMICRON CT ANALYZER CURRENT TRANSFORMER TESTING, CALIBRATION AND ASSESSMENT

• Highest measurement accuracy: 0.02 % / 1 min when calibrating on site
• Very small and lightweight (< 8 kg / 17.4 lbs), easy to transport for on-site testing
• Automatic evaluation according to IEC, IEEE and to customized or local/national standards

 
OMICRON COMPANO 100 PRIMARY INJECTION, SECONDARY INJECTION AND BASIC PROTECTION TEST SET

• Accurate output of desired value
• Run complex predefined sequences and ramps
• Polarity check signal generation for quick setup of wiring tests

 
OMICRON ISIO 200 BINARY INPUT/OUTPUT (I/O) TERMINAL WITH IEC 61850 INTERFACE

• Testing of complex protection schemes with CMC test sets
• Remote control of binary outputs
• Indication of GOOSE timeouts and malfunctions using alarm output contact
• Integration of conventional devices into IEC 61850 systems

 
OMICRON CMC 353 COMPACT AND VERSATILE THREE-PHASE RELAY TEST SET

• Compact design and light weight
• High current amplitudes for 5 A relay testing
• Powerful current sources for testing electromechanical relays

 
OMICRON OMS 605 SYSTEM PORTABLE ON-LINE PARTIAL DISCHARGE DIAGNOSIS AND MONITORING SYSTEM FOR VARIOUS ELECTRICAL ASSETS

• All-in-one solution for on-line PD diagnosis and monitoring
• Easy to transport to different locations
• Plug-and-play modules for fast system set-up
• Compatible with a variety of PD sensors