Extech MN30 Multimetru True RMS AutoSensing™ + NCV

• Checks for Carbon Dioxide (CO2) concentrations
• Maintenance free dual wavelength NDIR (non-dispersive infrared) CO2 sensor
• Triple LCD simultaneously displays CO2 , Temperature and Relative Humidity
• Measurement ranges: CO2 - 0 to 4,000ppm; Temperature - 32 to 122°F (0 to 50°C); Humidity - 10 to 90%RH
• Datalogger stores readings on an SD card in Excel® format for easy transfer to a PC

 

• 99 memory locations for preset voltage and frequency output settings
• User-programmable Over Current Protection
• Programmable through the built-in RS-232 interface
• Data acquisition mode captures readings to your PC with a user-programmable sampling rate of 2 to 65,535 seconds
• Complete with AC power cord, RS-232 to USB cable and software

 

• Datalogging of single and 3-phase/3-wire or 3-phase/4-wire systems (up to 52,428 single phase readings or 17,476 3-phase readings)
• Flexible clamp probes can be used for wrapping around bus bars and wire bundles
• Large backlighting LCD displays up to 35 parameters in one screen
• Clamp-on True RMS power measurements with on-screen Harmonics display
• Simultaneous display of Harmonics and Waveform

 

• Built-in Datalogger stores up to 1,012 readings (single record/continuous datalogging)
• Four simultaneous displays of Watts, Power Factor or VA, Voltage or Hz, Amps
• True RMS Voltage & Current measurements of sine, square, triangular and distorted wave forms with a crest factor < 5
• Plug device to be tested directly into the Power Analyzer

 

• Sensor wavelength range 320 to 390nm
• UV sensor with cosine correction measures irradiance from UVA light sources up to 20.00mW/cm²
• Backlit LCD to view in dimly lit areas
• Zero function
• Data Hold and Min/Max functions

 

• True RMS for accurate AC measurements
• 6000 count backlit LCD display
• Low Impedance (LoZ) prevents false reading caused by ghost voltages
• Low Pass Filter (LPF) for accurate measurements of variable frequency drive signals

 

• Constantly calculates and adjusts the Voltage and Current limit points according to available maximum power (160W)
• At maximum current (10A), voltage is limited to 16V
• At maximum voltage (42V), current is limited to 3.8A
• Dual action rotary encoder control with push knob for fine and coarse tuning

 

• Checks for Carbon Dioxide (CO2) concentrations
• Maintenance free NDIR (non-dispersive infrared) CO2 sensor
• Indoor Air Quality displayed in ppm with Good (0 to 800ppm), Normal (800 to 1200ppm), Poor (>1200ppm) indication
• User programmable Visible and Audible CO2 warning alarm

 

• True RMS for better accuracy when measuring distorted waveforms
• 2000 count large backlit dual LCD with easy-to read digits
• Low current capability with resolution to 0.1µA
• Input fuse protection
• Max Hold, Data Hold and Auto power off
• Complete with test leads and 9V battery

 

• Quickly indicates the moisture content of materials with Pinless technology without damaging the surface
• Remote Pin-type probe (MO290-P included) allows for contact moisture readings (3ft/0.9m cable length)
• Manually store/recall up to 20 labeled readings
• Works on multiple wood types and other building materials
• Easy to read, large dual display with automatic backlight feature