Osciloscop analogic 2 x 100 MHz GW Instek GOS-6103

• 100 MHz bandwidth, Delayed Sweep
• 2 analog channels
• 10 Sets Memory for Front Panel Setting Save & Recall
• Time Base Auto-range
• Cursor Readout with 7 Measurements

 

• Auto Series and Parallel Operation
• Constant Voltage and Constant Current Operation
• Low Ripple and Noise
• Internal Select for Continuous or Dynamic Load

 

• Safety design: OVP,OCP & OTP;Output ON/OFF control
• Self-test and software calibration
• Highly visible vacuum-fluorescent display
• Front and rear output terminal

 

• Wide frequency range from 1uHz to 80/50MHz
• High 200MSa/s sampling rate
• 16-bit Amplitude Resolution
• Output from any section of 1M-point-long waveform

 

• 100 MHz bandwidth, Delayed Sweep
• 2 analog channels
• 10 Sets Memory for Front Panel Setting Save & Recall
• Built-In 6 digits Universal Counter
• Time Base Auto-range
• Cursor Readout with 7 Measurements

 

• The basic precision of DC voltage: 0.02%
• Auto/manual Ranging
• True RMS (AC,AC+DC) measurements
• 11 different measurement functions

 

• Easy-Operating Tester, Particularly be Designed for the Digital IC
• Supported Device:74/54/40/45 Serial, Drive 2xxx
• Small, Portable, Light and Power-Saving, Usable With Battery
• Average Search Time: 0.6 Second
• Display: 16 Characters in 1 Line LCD
• Test Pins: 14~24 Pins

 

• Two data display modes
• Standard : two major measurement items + six secondary measurement items
• Simple : displaying test data of four different measurement items
• Met the requirement of IEC 62301 power measurement
• Voltage/ current test frequency bandwidth : DC~6kHz

 

• Built-in 6 Digits Counter up to 150MHz/High Resolution
• Output Waveform : Sine,Square,Triangle,Ramp,Pulse,Sweep,Gate or Burst
• INT/EXT AM/FM Modulation
• GCV Output for Synchronization

 

• Output Voltage Rating : 80V/800V
• Output Power Rating : 400W~800W
• Constant Power Output for Multi-Range(V&I)Operation
• Series and Parallel Operation(2 Units in Series or 4 Units in parallel Maximum)