Osciloscop analogic 2 x 200 MHz GW Instek GOS-6200

• Output ON/OFF
• Analog Control (Remote I/O) for Output ON / OFF
• Set View function for checking an original V / I setting during output on
• Key Lock Function

 

• Arbitrary Waveform Power Output
• Power Amplifier of External Signal
• Measurement Functions: Voltage, Current, Power ,Frequency, Power Factor,CF,and Harmonic Current
• Capacitor Input Load Supported

 

• 500VA AC Test Capacity
• 240x64 Ice Blue Dot matrix LCD
• Sweep Function for DUT characteristic analysis
• Insulation resistance measurement up to 50GO(GPT-9903/9904)
• Manual/Auto Mode
• Interface : RS-232C, USB device, Signal I/O and GPIB (optional)

 

• High Voltage 1000V and 20A Current Range
• All Range with Protection Circuit
• 0.1% DCV Accuracy
• Auto Zero Circuit

 

• Constant Voltage and Constant Current Operation
• Remote Control for External Programmability
• Internal Select for Continuous or Dynamic Load
• Low Ripple and Noise

 

• 200MHz Bandwidth, Delayed Sweep
• 2 analog channels
• Built-in 6 Digits Counter
• Cursor Readout with 7 Measurements

 

• Power on Configuration
• Internal Sense Control( Disable/ front panel/ rear panel)
• Voltage trigger function
• Output delay function

 

• 30 MHz bandwidth
• 2 analog channels
• 1mV/div ~ 20V/div
• Cursor Measurement, 6 Digit Frequency Counter, 10 sets Memory for Front Panel Setting Save & Recall

 

• Dual Measurements to perform two selected measurements simultaneously
• Bright Vacuum Fluorescent Display (VFD)
• Provide AC+DC Voltage or Current Measurement Functions
• 11 Measurement Functions & 10 Math Functions

 

• Input/output signal ground independent of housing and signal ground between channels also insulated.
• Synchronized phase operates up to 6 units and 12 channels
• Pulse waveform parameters can be set independently for more precise timing
• Harmonic signal generator