Generator semnal test satelit si cablu coaxial 4 frecvente purtatoare Promax RP-080

Cod: Promax RP-080


 

Brosura produs PDF, 0.05 Mb

Descriere

The RP-080 is a handy, versatile and easy to use signal generator with which satellite receivers and coaxial cables of buildings can be checked. It generates up to 4 independent pilot carriers with selectable level (from 75 to 105 dBµV).

 

 

  • 4 PILOT CARRIERS: 85 MHz, 750 MHz, 1000 MHz, 2150 MHz
  • Selectable and independent carrier level for each one: from 75 to 105 dBµV
  • LED indicators for each carrier output level
  • 13, 18 V and 22 kHz signal detection.
  • Power supply from the LNB or external DC supply.
  • Ergonomic and compact format.
 

Alte produse PROMAX

MPEG-2 TRANSPORT STREAM RECORDER, PROCESSOR, PLAYER PROMAX TG-140

• record a transport stream continuously for several hours up to 15 hours at 20 Mbps
• ASI transport stream Input, Maximum data rate 150 Mbps
• ASI transport stream Output, SPI parallel transport stream Output, Maximum data rate 90 Mbps
• Hard disk 160 GB Storage Capacity
• USB, Ethernet interface

 

RECEPTOR PACHETE IP -> 4 X DVB-ASI TRANSPORT STREAM PROMAX DT-324

• IP INPUT: Ethernet 100/1000 Mbps. RJ45 connector
• TS OUTPUT: 4 x DVB-ASI. BNC Female connector, 75 ?
• Communication protocol: UDP or RTP/UDP communication protocol
• Transmision methode: MULTICAST / IGMP Version 2
• Payload: From 1 to 7 packets MPEG-2

 

AMPLIFICATOR PUTERE RF DVB-T SEMNAL COFDM 1W 30DBM PROMAX DT-730

• FREQUENCY BANDS: UHF from 470 MHz ~ 862 MHz
• 1 W RF power amplifier for COFDM signals
• both for single carrier or multicarrier system
• provides an amplified output of 30 dBm (137 dBµV)
• preserves the original signal quality and maintains a low noise levels

 

APARAT SUDURA FIBRA OPTICA PROMAX PROLITE-40B

• Automatic fusion splicing on 3 axis (X,Y, Z)
• Maximum accuracy
• Fibre aligning by means of core aligning method
• Single or simultaneous axis view.
• Fibre core can be display clearly.
• 5.7" colour LCD display.
• Temperature and atmospheric pressure indicators.
• Auto check quality of cleaved end face.

 

HEADEND DISTRIBUTIE TRANSMODULARE TV SATELIT DVB-S -> TV DIGITAL TERESTRIAL DVB-T PROMAX DTTV

• DVB-T (DTT) output
• converts analogue/ digital video source to DVB-T with a max 200 programmes in the UHF band
• transmodulate Satellite TV channels to Digital Terrestrial Television multiplexes
• system allows to re-organise the spectrum, adding the off-air DTT channels received in the region
• encoding video-audio channels
• remotely controlled through Ethernet

 

GENERATOR VIDEO SEMNAL TV CABLU CATV MULTI-PURTATOARE 5..100 MHZ PROMAX RP-100/ RP-100Q

• RP-100: 2 generated carrier pilots
• RP-100Q: 2 generated carrier pilots
• 5 MHz to 100 MHz Frequency Range
• 90 to 110 dBµV (30-50 dBmV) adjustable in steps of 1 dB output level
• select independent frequencies for each pilot
• internal rechargeable battery

 

GENERATOR SEMNAL TV VIDEO ANALOG PAL/ NTSC/ SECAM PROMAX GV-898+/ GV-798+

• PAL / PAL60 / SECAM / NTSC Multistandard
• GV-898+ : Vestigial Side Band Modulation - VSB
• GV-798+ : Double Side Band Modulation - DSB
• YPbPr outputs
• 4:3, 16:9 & 14:9 formats (WWS signals)
• NICAM / Zweiton sound
• RS-232 remote operation

 

GENERATOR RADIO FRECVENTA SIMULATOR IF/ UHF SATELIT PROMAX RP-050

• test the frequency response of an entire television system prior to having the antennas or the Headend installed
• can be used for the test and certification of TV and satellite wiring, headend trouble shooting
• 1050 / 1575 / 2100 MHz L BAND TEST PILOTS
• 537.5 MHz UHF TEST PILOT

 

POWER-METRU FIBRA OPTICA PROMAX PROLITE-23

• 850, 1300, 1310, 1490, 1550 nm CALIBRATED WAVELENGTH
• Pocketsize, large LCD display, easy to use
• Measure six wavelengths through a single connector
• Direct loss measurements units in dB
• Absolute power measurement units in dBm and W (or µW)
• PC software available for testing data collection and report generation

 

COMBINER 4 X DVB-T -> 1 X DVB-T PROMAX DT-722

• FREQUENCY MARGIN: From 50 MHz (C-2) to 860 MHz (C-69)
• INPUTS: 4 inputs Female BNC, 75 ? impedance
• RF OUTPUT: 1 female BNC output, 75 ? impedance
• output designed to mix output RF signals of COFDM modulators and transmodulators with DTT channels