CATV Cable Network Analyzer BER, MER, QAM Promax-10 SE
OBSOLET PRODUCT ( * OUT OF USE )

Code: Promax-10 SE


 

Datasheet PDF, 0.43 Mb
 

Description

  • BER & MER ON QAM DIGITAL SIGNALS
  • MULTISTANDARD ANNEX A / B / C
  • ANALOGUE CHANNELS
  • DIGITAL CHANNELS
  • BROADBAND POWER DETECTION
  • SCAN
  • C/N, CSO, CTB
  • TRANSIENT DETECTOR
  • MAX AND MIN HOLD
  • CHANNEL POWER BY INTEGRATION
  • TILT
  • DATALOGGER
  • PRINTING
  • CONNECTION TO PC

 

The PROMAX-10 SE incorporates the measurements for installation, verification and maintenance of reception and distribution systems for FM radio, MATV, CATV and MMDS, including the sub-band (return path). Now it includes a new function to measures power level measurement over a complete frequency band, very useful for detecting saturation in the input of some broadband demodulators. PROMAX-10 Premium is a multistantard instrument, so it can be used in any network in the world.

 

 

FUNCTIONS

Level meter, Logger, Scan, Tilt, Spectrum analyser, Transient detector, Cable digital analyser

DIGITAL MEASUREMENTS

Channel power, C/N, Bit Error Rate /Pre-BER, Post-BER), MER, DVB-QAM constellation

ANALOGUE MEASUREMENTS

Level, C/N, C/A ratio, CSO-CTB intermodulation

 

More products PROMAX

RF POWER DVB-T AMPLIFIER COFDM SIGNAL 1W 30DBM PROMAX DT-730

• FREQUENCY BANDS: UHF from 470 MHz ~ 862 MHz
• 1 W RF power amplifier for COFDM signals
• both for single carrier or multicarrier system
• provides an amplified output of 30 dBm (137 dBµV)
• preserves the original signal quality and maintains a low noise levels

 

TRANSMODULATOR DVB-S -> DVB-T PROMAX DT-202

• DVB-S FI INPUT: 2 independent DVB-S FI inputs
• RF OUTPUT: 2 combined DVB-T multiplexes
• PID Filtering with Filtering Table up to 32 PID
• Measurement: Bitrate of the output multiplex
• includes an internal combiner that delivers a single DVB-T output with high C/N

 

PLC POWER LINE COMMUNICATIONS SPECTRUM ANALYZER & NOISE GENERATOR 1..50 MHZ PROMAX PROPOWER-5/1

• 1 - 50 MHz PLC Spectrum Analyser Propower-5
• 1 - 50 MHz PLC Noise Generator Propower-1
• field use and combined use
• st the network response to PLC test signals

 

HOME DIGITAL VIDEO MODULATOR DVB-T PROMAX EN-106

• sends audio / video signal from TV satellite receivers, closed-circuit television cameras (CCTV) or video players to DVB-T
• Video Input: 1 x PAL?/?NTSC / SECAM
• Audio Input: 2 x Mono /?Stereo
• Video Compression: MPEG-2 MP@ML 720x576, 25 fps (PAL), 720x480, 30 fps (NTSC)
• Audio Compression: MPEG-1 Layer II Stereo, Mono, Dual, Joint Stereo
• FREQUENCY MARGIN: From 100 to 865 MHz (channels S01 to C69)

 

DISTRIBUTION TRANSMODULATING HEADEND SATELLITE DVB-S -> DIGITAL TERESTRIAL DVB-T PROMAX DTTV

• DVB-T (DTT) output
• converts analogue/ digital video source to DVB-T with a max 200 programmes in the UHF band
• transmodulate Satellite TV channels to Digital Terrestrial Television multiplexes
• system allows to re-organise the spectrum, adding the off-air DTT channels received in the region
• encoding video-audio channels
• remotely controlled through Ethernet

 

CONVERTER ASI-TRANSPORT STREAM-> IP PACKETS PROMAX DT-421

• TS INPUT: 4 x DVB-ASI
• IP OUTPUT: Ethernet 100/1000 Mbps. RJ45 connector
• Communication Protocol: UDP or RTP/UDP
• Transmission methode: MULTICAST
• Payload: 7 MPEG-2 packets

 

SFN/MFN MODULATOR ASI-TS MPEG -> DTMB PROMAX MO-280

• fully compliant with the GB20600-2006 and the GY/T 229. 1-2008 standards
• 10 MHz GPS reference input
• MPEG-2 TS INPUTS: 2xSerial ASI-TS MPEG-2 inputs
• RF Output: 45 to 875 MHz (1 Hz steps). MER > 38 dB

 

PORGRAMMABLE CALIBRATED OPTICAL FIBER VARIABLE ATTENUATOR 60 DB FTTH PROMAX PROLITE-360

• Access all data from a single screen
• Up to 10 programmable attenuation sequences
• Low insertion loss (< 2 dB)
• Calibrated for standard FTTH networks wavelengths
• Attenuation is indicated in both absolute and relative modes
• USB to PC connection

 

COMBINER 16 X DVB-T -> 4 X DVB-T PROMAX DT-700

• INPUTS FOR EACH COMBINER: 4 BNC female inputs 75 ? (16 total)
• OUTPUTS FOR EACH COMBINER: 1 BNC female output 75 ? (4 total)
• allows many different combinations to adapt to the needs of each system as best as possible
• used to mix the output RF signals of the COFDM modulators and transmodulators
• preserves better the original quality and maintains lower noise levels

 

CATV/ SMATV COAXIAL CABLE TEST SIGNAL GENERATOR 5..2150 MHZ PROMAX RP-110

• CATV and SMATV coaxial cable bands
• six pilots of frequency and level selectable by the user
• 8 preset memories for the six pilot signals.
• Frequency resolution: 25 kHz.
• User interface in several languages.
• USB to PC connection for firmware updating and to configure frequencies and levels.