YOKOGAWA Digital Insulation Tester MY40

Cod: YOKOGAWA MY40


 

Brosura produs PDF, 0.86 Mb
 

Descriere

The MY40 insulation tester is used to measure the Insulation resistance that represents the state of insulation of electric equipment or circuits; It is one of the important measurement parameters in terms of safety and security. The MY40 comes with 4 voltage/resistance ratings on an easy-to-view large display, and incorporates a double-action safety mechanism to keep the user from harm.

 

Features:

  • 3 1/2-digit LCD;
  • For each rating, you can save as many as 20 measurements at desired memory address numbers.
  • Four AA (R6P) batteries the tester retains the measured resistance for approximately 5 seconds after the MEAS switch is turned off.
 

Alte produse YOKOGAWA

YOKOGAWA CLAMP-ON TESTER CL135 (TRUE RMS, ACA, ACV, 600A)

• AC current measurement with current ranges up to 600A
• AC voltage and resistance measurements
• 30mm in diameter of measurable conductor
• True RMS Display
• Data hold function

 

YOKOGAWA AQ6373B ANALIZOR SPECTRU OPTIC VIZIBIL 350 - 1200 NM

• Max safe input power: +20 dBm
• Level sensitivity: -80 dBm
• Dynamic range: ?60dB
• Single-mode, Multimode, and Large-core fibers
• Built-in optical alignment source

 

YOKOGAWA MANOMETRU DIGITAL MT210 MT210F

• ±0.01%, with a maximum allowable input of 500 kPa (130 kPa-range model)
• Offering low differential pressure of 1 kPa to a high gauge pressure of 3000 kPa
• Normal speed, medium speed, and high speed (MT210F series)

 

YOKOGAWA TESTER DIGITAL IMPAMANTARE EY200 (DIGITAL)

• 2P Test leads (for simplified measurement) has a structure that both the safety alligator clip and the test probe are available
• Warns when earth resistance of auxiliary earth spikes exceeds the permissible limit
• Convenient carrying soft bag for accessories etc.
• 3-Pole Earth Resistance Measurement (Precise Measurement)

 

YOKOGAWA -Q1300 SERIES 1G/10G ETHERNET MULTI FIELD TESTER

• Optical and electrical measurement ports for 10M to 1G (AQ1301) and 10M to 10G (AQ1300) are available
• Built-in Optical power meter (factory-installed option for the AQ1300)
• Equipped with a variety of test functions to evaluate Ethernet performance, such as a throughput test, latency measurement, bit error rate test, and PING test.

 

YOKOGAWA - AQ6376 THREE MICRON OPTICAL SPECTRUM ANALYZER

• Long wavelength range: 1500 to 3400 nm
• Gas purging ports to reduce water vapor effects
• Built-In cut filter for high order diffracted light
• Double Speed Mode to further enhance fast measurement speed

 

YOKOGAWA MULTIMETRU DIGITAL PORTABIL TY710

• Conforms to safety standards EN61010-1 1000V CAT., 600V CAT.
• Safety shutters for preventing erroneous insertion of test leads into current measurement terminals
• Operating temperature range -20 to +55C
• Storage temperature range -40 to +70
• Closed Case Calibration

 

YOKOGAWA PROCESS MULTIMETER CA450

• Simultaneous 24 V loop power and mA measurement
• HART mode setting with loop power (250 OHM resistance)
• High accuracy signal measurement: DC mA 0.05%/30.000 mA
• Handheld DMM function
• Peak/Hold function for DCS power peak-to-peak measurement

 

YOKOGAWA STAND CALIBRARE PRESIUNI PNEUMATICE MC100

• Low temperature coefficient Zero point: ±0.003% of full scale/°C Span: ±0.002% of full scale/°C
• Divided output function with as many as 20 steps
• Auto-step output function
• Sweep output function

 

YOKOGAWA - DIGITAL LUX METERS 51000 51011 51012 51021

• Wide measurement range, high accuracy
• Spectral response characteristics for visible range
• Good oblique incident light characteristics
• USB communication and USB power supply
• Recorder output