Privacy policies

GDPR data Terms of use Cookies policy Privacy policy Delivery and Payment How to order?
I agree with terms and conditions Continue
 
office@distek.ro  +40 760952425   Ask price (0) 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 


Rain Detector and Athmospherical Precipitation Delta Ohm HD2013.2

Code: Delta Ohm HD2013.2


 
Datasheet PDF, 0.4 Mb

Description

The HD2013.2 is a rain detector based on the capacity principle. The capacity

value of the sensitive element, on an alumina rest, changes according to the

surface dampened by raindrops. An integrated heater keeps it dry, evaporates

water and prevents false signals caused by fog or dew. The heater also

activates at low temperatures, melting the snow and allowing to detect snow

precipitations. The instrument external circular dome acts as a windshield for

the sensor, preventing false indications. The instrument is equipped with three

different outputs: a "Rain ON/OFF" output, which detects whether it is raining/

snowing (ON) or not (OFF), also used to control a relay coil or similar devices; a

0…1V voltage analogue output (calibrated) and a 1,5…6KHz frequency output

(not calibrated), which provide an accurate indication of current precipitation

intensity. The ON/OFF output comes with a delay circuit that indicates the

"rain over" condition with a 2 minute delay, so that the "rain over" condition is

distinguished from the "light rain" one. The heater can be disabled when power

consumption is critical. To do it, set the Heater OFF input on 0V.

If requested when ordering, a bird spike, consisting of a 6-spike ring (spike

height: 60mm, diameter: 3 mm), can be mounted.

 

 

Typical Applications

The rain detector can be used either as a separate device, or connected to a data

logger system (for example: in a weather station). In figure 1, the HD2013.2 ON/

OFF output is connected to a relay coil that powers an engine: should it rain, the

ON/OFF output will energize the relay coil, which will close the normally open

contact (in this case the rain detector is employed as part of a control system,

such as, for example, for closing windows). Warning: when the HD2013.2 is

connected to a relay coil, use always a protection diode, as shown in figure 1.

 

Installation and Maintenance

Place the detector far from buildings, trees, etc…, taking care that no object

is over the detector, as it might prevent rain detection. Use the supplied

accessories to mount the instrument; the bracket can be fixed to a post having

a diameter from 30 to 50mm; the post can be either horizontal or vertical

thanks to the bracket double drilling. A standard 5-m cable is supplied for the

electrical connection with an IP68 connector to be inserted at the bottom of

the instrument: the colours of the leads and the relating functions are to be

found in the technical specifications. To ensure good immunity from noises, it is

recommended to connect the cable braid to the earth and to keep the heater and

the electronics earth leads separate. Clean the sensor regularly with a cotton

flock soaked in distilled water; in case of ingrained dirt, mild cleansers can be

used in moderation.

The sensor is fragile, as it is placed on an alumina rest, thus handle it with

care!

 

More products SENSECA

MULTIPARAMETRIC TESTER FOR ELECTROCHEMICAL MEASUREMENTS: PH, CONDUCTIVITY, DISSOLVED OXYGEN, TEMPERATURE, CONCENTRATION, SOLIDS, SALINITY DELTA OHM HD98569

• portable multi-parameter data logger for electrochemical measures: pH, conductivity, dissolved oxygen and temperature
• large back-lighted LCD display
• pH, mV, redox potential (ORP) with pH, redox or combined pH/temperature electrodes complete with SICRAM module
• conductivity, resistivity in liquids, total dissolved solids (TDS), and salinity with combined 4-ring and 2-ring conductivity and temperature probes with SICRAM module.
• Concentration of dissolved oxygen in liquids (in mg/l), saturation index (in %)

 
HANDHELD DIGITAL THERMOCOUPLE THERMOMETER K J T E DELTA OHM HD2328.0

• Thermocouple thermometer for probes type K, J, T, E
• Two inputs for miniature thermocouple connectors
• Storage of maximum, minimum, average valu
• Functions: REL, HOLD and auto power off which can be disabled,
• IP 67 protection degree

 
LABORATORY BENCHTOP CONDUCTIVITY-METER-THERMOMETER WITH LIQUID RESISTIVITY, DISSOLVED SOLIDS TDS DELTA OHM HD2206.2

• Bench-top conductivity meter-Thermometer with back-lighted display,
• with inputs for measurements of conductivity, liquid resistivity, total dissolved solids (TDS) and the salinity by conductivity and temperature
• combined probes with 2 or 4 electrodes with direct input or with SICRAM module.
• Datalogger of conductivity or resistivity or TDS and temperature.
• RS232 C or USB 2.0 serial output for data download to a PC or printer from memory or in real time.
• Input for Pt100 or Pt1000 temperature probes provided with SICRAM module.

 
HVACR DATALOGGER FOR AIR SPEED, FLOW, PRESSURE, TEMPERATURE DELTA OHM DO2003

• HVACR Datalogger to measure: air speed and flow rate with the hot wire probes, vane probes, Pitot tube probes,
• Pt100 temperature probes for immersion, pointed and for surface,
• combined temperature/relative humidity probes.
• Pressure up to 2000 mbar and barometric pressure.
• Max-Min-Med, Rel measurements.
• Storage up to 12,000 readings.
• Serial output RS232C

SILICON PHOTODIODE PYRANOMETER WITH GLOBAL SOLAR RADIATION MEASUREMENT FOR PHOTOVOLTAIC PANELS DELTA OHM LP SILICON-PYRA04

• LP Silicon-PYRA 04. pyranometer
• measures the global solar radiation (W/m2) by using a silicon photodiode (400nm-1100nm).
• special geometry and the diffuser allow to have a pyranometer field of view of 180 degrees according to cosine law.
• The pyranometer is suitable for the measurement of natural sunlight.

 
LABORATORY TESTER FOR ELECTROCHEMICAL PARAMETERS: PH, CONDUCTIVITY, DISSOLVED OXYGEN, TEMPERATURE, CONCENTRATION, SOLIDS, SALINITY DELTA OHM HD22569.2

• bench top instrument for electrochemical measures: pH, conductivity, dissolved oxygen, and temperature.
• It is are fitted with a large backlighted LCD display.
• pH, mV, redox potential (ORP) with pH, redox electrodes or electrodes with separate reference;
• conductivity, resistivity in liquids,
• total dissolved solids (TDS) and salinity with combined 4-ring and 2-ring conductivity/
• temperature probes with direct input or SICRAM module;
• concentration of dissolved oxygen in liquids (in mg/l) and saturation index (in %),

 
THERMO HYGROMETER DELTA OHM HD2301.0

• Thermo hygrometer, instrument measuring range for temperature -200°C +650°C with probe TP47...
• humidity 0.0...100.0%RH
• Storage of maximum, minimum, average value.
• Functions: REL, HOLD and auto power off which can be disabled
• IP 67 protection degree

 
NET RADIOMETER WITH 4-COMPONENTS FOR SOLAR RADIATION MEASUREMENTS DELTA OHM LP NET14

• LP NET 14 is a 4-component net-radiometer for the measurement of the net radiation between 0.3µm and 45 µm.
• consists of two pyranometers: one for the measurement of the global radiation Esw? and the other one for the measurement of the reflected solar radiation Esw?
• pair of pyrgeometers: one for the measurement of the infrared radiation emitted by the sky EFIR? and the other one for the infrared emitted by the ground surface EFIR?
• equipped with a temperature sensor (NTC).

 
PORTABLE LABORATORY TURBIDITY-METER FOR LPROCESS IQUIDS, DRINKING WATER, WASTE WATER DELTA OHM HD25.2

• Portable and bench turbidity meter equipped with 3 photodetectors and two light sources
• it measures according to the standard EPA 180.1, ISO-NEPH (ISO 7027), EBC and ASBC.
• Automatic calibration,
• datalogger,
• data downloading to PC by RS232C or USB 2.0 through the software DeltaLog11

 
METEO PIRGEOMETER FOR INFRARED RADIATION MEASUREMENT DELTA OHM LP PIRG01

• The pyrgeometer LP PIRG 01 is used to measure the far infrared radiation (FIR).
• Its use is mainly in the meteorological field.
• Measures are referred to radiations with wavelength greater than 4.5 µm .
• The far infrared radiation derives from the measure of the thermopile output signal and from the knowledge of the instrument temperature. The temperature measure is performed by a 10kO NTC which is inside the body of the pyrgeometer.
• The pyrgeometer can be used also for the study of energy balance