Analog Oscilloscope 2 x 100 MHz GW Instek GOS-6103C

• Pulse Current Measurement
• Long Integration Current Measurement
• Sequence Function (Sequential power output)
• Built-in Battery Simulation Function

 

• Consecutive test frequency
• Basic accuracy : 0.05%
• Measuring speed up to 25ms (max.)
• Full frequency range or spot OPEN/SHORT

 

• 100 MHz bandwidth, Delayed Sweep
• 2 analog channels
• 10 Sets Memory for Front Panel Setting Save & Recall
• Time Base Auto-range
• Cursor Readout with 7 Measurements

 

• Input/output signal ground independent of housing and signal ground between channels also insulated.
• Synchronized phase operates up to 6 units and 12 channels
• Pulse waveform parameters can be set independently for more precise timing
• Harmonic signal generator

 

• Constant Voltage and Constant Current Operation
• Remote Control for External Programmability
• Internal Select for Continuous or Dynamic Load
• Low Ripple and Noise

 

• 30000 Counts Display
• High Accuracy 0.05%
• Hi/Lo Comparator and Limit Percent Setting
• Measurement of REL, Actual and % Value
• Continuous or Triggered Measurement Mode

 

• 200VA AC Test Capacity
• 240x64 Ice Blue Dot matrix LCD
• Manual/Auto Mode
• Controllable Ramp-up Time
• True RMS Current Measurement
• High resolution: 1uA for measuring current, 2V for setting voltage
• Interface : RS-232C, USB device, Signal I/O and GPIB (optional)

 

• Constant Power Output for 5 Times Multi-range(V&I) Operation
• Natural Convection Cooling Design (Fanless Structure)
• Preset Memory Function
• Output ON/OFF Delay Function
• CV, CC Priority Mode

 

• 0.01% High Regulation
• Constant Voltage and Constant Current Operation
• Low Ripple and Noise
• Overload and Reverse Polarity Protection

 

• Output Voltage Rating : 80V/800V
• Output Power Rating : 400W~800W
• Constant Power Output for Multi-Range(V&I)Operation
• Series and Parallel Operation(2 Units in Series or 4 Units in parallel Maximum)