RF USB Power Meter 10 MHz..26.5 GHz TTi ST265SMA

• Frequency, period, pulse width, frequency ratio, duty cycle, and event counter modes
• DC to 6000MHz range, 0.001mHz resolution
• High impedance measurement up to 125 MHz
• AC or DC coupling, 1M/50Ohm selection, polarity invert
• Switchable attenuator, threshold control

 

• 10 MHz ..18.5 GHz bandwidth
• Measurement range from -50 dBm to +20 dBm
• Replacement solution for conventional power meter and sensor combination
• Simple USB connection to laptop or PC
• Use multiple sensors on one laptop or PC

 

• High power 35V/10A & 18V/20A
• Compact & lightweight high power units
• Bench or rack mounting, front & rear terminals
• Very low noise, excellent transient response

 

• 10 MHz to 1 GHz frequency range
• 1 kHz setability, +/-2ppm frequency stability
• -127 dBm to +7dBm amplitude, 0.1dB steps
• FM modulation, internal or external

 

• 0.003Hz to 3MHz frequency range
• High waveform quality at all frequencies & levels
• 2mV to 20V pk-pk from 50 Ohms or 600 Ohms

 

• 1 µHz to 50 MHz range(sine and square)
• 1 µHz resolution
• 128K points at up to 125MS/s Arbitrary waveforms
• True pulse generator with variable delay and variable rise/fall

 

• 40,000 counts, auto/manual ranging
• Accuracy and resolution, 0.08%, 10µV, 10mW
• Large and bright LED display (14mm/0.56")
• True RMS ac functions, wide ac bandwidth
• Frequency measurement

• 1MHz to 1300MHz frequency range
• Resolution bandwidths of 1MHz, 280kHz or 15kHz
• -96dBm typical noise floor at -20dBm reference level
• Measurement in dBm or dBµV, mV or µW
• Zero span mode with AM and FM audio demodulation

 

• 40 MHz sine
• 50 MHz square
• 4-channel independent or linked
• 100 MSa/s sample rate
• 12-bit vertical resolution

 

• 0.1Hz to 10MHz frequency range
• Independent control of pulse frequency, width and delay
• 50ns minimum pulse width
• Squarewave, double pulse & delayed pulse modes
• Free-run, gated and triggered modes
• 50 Ohm output: 0.1V to 10V amplitude