Analog Oscilloscope 2 x 100 MHz GW Instek GOS-6103

• Touch Panel with Color LCD Display
• 9 Different Measurement Network to Simulate
• the Resistance of Human Body
• 8 Different Types of Leakage current for Medical
• & General Electrical Equipment
• Various Leakage Current Measuring Mode:DC/AC/AC+DC/AC Peak
• Upper & Lower Limitation for PASS/FAIL Judgment
• Meter Mode with SELV/CONV Function
• 50 Preset Test Conditions Conform to IEC 60990;
• 30 Sets Memories for Customer Defined
• Various Standard Interfaces RS232/GPIB/USB Host & Device/EXT I/O

• 20MHz Bandwidth
• 100MS/s Real-Time Sampling Rate
• True RMS Multimeter: Volt, AMp, Ohm, Continuity, Diode
• Dual Independent Floating Isolated Channels
• Trigger Mode: Free Run, Single Shot, Edge, Video
• USB Interface
• 6 Hour Capacity Li-ion Rechargeable Battery
• 3.8" Color LCD, Resolution: 320 x 240
• Light Weight: 690g

 

• Safety design: OVP,OCP & OTP;Output ON/OFF control
• Self-test and software calibration
• Highly visible vacuum-fluorescent display
• Front and rear output terminal

 

• 100 MHz bandwidth, Delayed Sweep
• 2 analog channels
• Cursor Readout with 7 Measurements

 

• High Resolution 10mV, 1mA
• High Stability, Low Drift
• Over-Voltage, Over-Current, Over Temperature Protection
• Intelligent Fan Control (Changes by Output Power)

 

• Frequency from 10Hz ~ 1MHz
• 0.02% Low Sine Wave Distortion (GAG-810 Only)
• 6 Steps Output Attenuator
• EXT SYNC Function

 

• Frequency Range : 150kHz ~ 3GHz
• RBW Range : 30kHz, 100kHz, 300kHz, 1MHz
• ACPR/CHPW/OCBW Measurement
• Presentation Material for Training Courses
• Support Interface : USB Device/Host, RS-232C
• 5.6" TFT LCD with VGA Output

 

• Constant Voltage and Constant Current Operation
• Internal Select for Continuous or Dynamic Load
• Low Ripple and Noise
• Overload and Reverse Polarity Protection

 

• Commands are compatible with Kikusui PLZ-4W model.
• Dynamic(Switching) Function:0.0166Hz ~20kHz
• Soft Start Function:Off / On(1~200ms, Res:1ms)
• Adjustable OCP / OVP / OPP / UVP Setting
• Short Circuit Function

 

• Output Voltage Rating : 80V/800V
• Output Power Rating : 400W~800W
• Constant Power Output for Multi-Range(V&I)Operation
• Series and Parallel Operation(2 Units in Series or 4 Units in parallel Maximum)